Xylem IM167 R8 Aquavar CPC (Centrifugal Pump Control) - Manual (Page 40)

40
10. Remove screws fastening the drive module trolley to the
pedestal.
WARNING! These screws are an important step during re-
assembly – the screws are required for grounding the drive.
11. R8: The front of the trolley includes support braces that fold
out. Lift each brace slightly and fold it out.
12. Remove screws that fasten the drive module to the extension
module.
CAUTION! The drive module is now separated and could
tip over. Use care when moving the drive module.
13. Pull on the handle to wheel the drive module out.
Drive Maintenance
See the AQUAVAR User’s Manual for drive maintenance
procedures, page 34.
Re-Assembly
Re-attach the modules in reverse order to the above.
R7
12
Pedestal
Trolley
10
10
13
INSTALLATION
(Frames R7-R8)