Xylem IM167 R8 Aquavar CPC (Centrifugal Pump Control) - Manual (Page 33)

33
Reinstall Cover
IP 21 / UL Type 1
1. Align the cover and slide it on.
2. Tighten the captive screw.
3. Reinstall the control panel.
IP 54 / UL Type 12
1. Align the cover and slide it on.
2. Tighten the captive screws around the edge of the cover.
3. Slide the hood down over the top of the cover.
4. Install the two screws that attach the hood.
5. Reinstall the control panel.
NOTE! The control panel window must be closed to
comply with IP 54/UL type 12.
6. Optional: Add a lock (not supplied) to secure the control
panel window.
Apply Power
Always reinstall the front cover before turning power on.
WARNING! The AQUAVAR will start up automatically at power up, if the
external run command is on.
1. Apply input power.
When power is applied to the AQUAVAR, the green LED comes on.
NOTE! Before increasing motor speed, check that the motor is running in
the desired direction.
Start-Up
The AQUAVAR has default parameter settings that are sufficient for many situations. However,
review the following situations. Perform the associated procedures as appropriate. Proceed to
Start-Up section of this manual.
INSTALLATION
(Frames R1-R6)