Xylem IM167 R8 Aquavar CPC (Centrifugal Pump Control) - Manual (Page 56)

56
Defaults
Group
Start-Up Range
Description
Single Synch- Multi- Constant Speed
11 Data Pump ronous Control Slave Control
1104 Motor Nom 11…345V/ Defines the motor voltage. 230/ 230/ 230/ 230/ 230/
Voltage 230…690V Equal to the value on the 460/ 460/ 460/ 460/ 460/
motor nameplate. 575 575 575 575 575
1105 Motor Nom 0.2*I
2hd
… Defines the motor current. 1.0* 1.0* 1.0* 1.0* 1.0*
Current 2.0*I
2hd
Equal to the value on the I
2hd
I
2hd
I
2hd
I
2hd
I
2hd
motor nameplate.
1106 Motor Nom Freq 10.0…500Hz Defines the motor nominal 60 60 60 60 60
frequency. Equal to the value
on the motor nameplate.
1107 Motor Nom RPM 50…18000 Defines the motor nominal 3550 3550 3550 3550 3550
RPM speed. Equal to the value on
the motor nameplate.
1108 Motor Nominal 0.2…2.0*P
hd
Defines the motor power (hp). 1.0*P
hd
1.0*P
hd
1.0*P
hd
1.0*P
hd
1.0*P
hd
Power Equal to the value on the
nameplate.
Group
Start/Stop Range Description
Single Synch- Multi- Constant Speed
12 Pump ronous Control Slave Control
1201 Start/Stop Defines the connections and Keypad Keypad Keypad Keypad Keypad
source of the start/stop
commands.
Comment - DI1 = Enable. 0= Disable,
1 = Enable. DI2 = Low Water. 0 = Fault,
1 = OK, DI3 = Estop 0 = Estop, 1 = OK,
After Estop restart from keypad required.
Keypad Start/Stop from keypad. After a
fault reset, the drive will restart
only if auto restart (1202) is set
to on. If auto restart is off the
drive must be started from the
keypad.
Fieldbus Start via fieldbus control word
1202 Auto Restart Selects whether the AV will On On On On On
automatically restart after a
power failure or fault reset.
Off Not selected
On Selected. The AV will automatic-
ally restart if conditions permit.
1203 Test Run Selects when the drive will Not Sel Not Sel Not Sel Not Sel Not Sel
perform a test run
Not Sel (default) Not selected
PARAMETER LISTINGS