Xylem IM167 R8 Aquavar CPC (Centrifugal Pump Control) - Manual (Page 23)

23
Install the Wiring
Conduit/Gland Kit
Wiring drives with the IP 21 / UL type 1 Enclosure requires a conduit/gland kit with the
following items:
• Conduit/gland box
• Screws
• Cover
The kit is included with IP 21 / UL type 1 Enclosures.
Overview
As you install the wiring, observe the following:
• There are four sets of wiring instructions – one set for each combination of drive enclosure
type (IP 21 / UL type 1 and IP 54 / UL type 12), and wiring type (conduit or cable). Be sure
to select the appropriate procedure.
• “Connection Diagrams” on page 24 shows the connection points on the drive.
• “Power Connections” on page 29 describes specific instructions for wiring the power. Use
in combination with the appropriate general procedure.
• “Control Connections” on page 29 describes specific instructions for wiring the control.
Use in combination with the appropriate general procedure.
• “Cable Terminals” on page 135 list the recommended tightening torques.
• Where applicable, observe EMC recommendations. For example, properly ground the wire
screen cable shields.
INSTALLATION
(Frames R1-R6)