Xylem IM167 R8 Aquavar CPC (Centrifugal Pump Control) - Manual (Page 22)

22
IP 54 / UL Type 12
1. If hood is present: Remove screws (2) holding hood in
place.
2. If hood is present: Slide hood up and off of the cover.
3. Loosen the captive screws around the edge of the cover.
4. Remove the cover.
Mount the Drive
IP 21 / UL Type 1
1. Position the AQUAVAR onto the mounting screws or bolts and
securely tighten in all four corners.
NOTE! Lift the AQUAVAR by its metal chassis.
2. Non-English speaking locations: Add a warning sticker in the
appropriate language over the existing warning on the top of
the module.
IP 54 / UL Type 12
For the IP54 / UL Type 12 enclosures, rubber plugs are required in
the holes provided for access to the drive mounting slots.
1. As required for access, remove the rubber plugs. Push plugs
out from the back of the drive.
2. Position the AQUAVAR onto the mounting screws or bolts and
securely tighten in all four corners.
NOTE! Lift the AQUAVAR by its metal chassis.
3. Reinstall the rubber plugs.
4. Non-English speaking locations: Add a warning sticker in the
appropriate language over the existing warning on the top of the module.
INSTALLATION
(Frames R1-R6)