Lenze EtherCAT control technology - Manual (Page 165)

DMS 3.1 EN 01/2011 TD17
L
165
Control technology | EtherCAT communication manual
Parameter reference
12 Parameter reference
This chapter complements the parameter list of the online documentation for the
industrial PC by the parameters of the Communication card MC-ETC:
 Parameters of the MC-ETC communication card in slot 1
( 166)
 Interface parameters of the MC-ETC communication card in slot 1
( 167)
 Parameters of the MC-ETC communication card in slot 2
( 182)
 Interface parameters of the MC-ETC communication card in slot 2
( 183)

Tip!
For general information about parameters please see the online documentation
for the industrial PC.

Note!
• Only one MC-ETC communication card can be installed per industrial PC. The
»WebConfig« designation of the card is MC-ETC1, independently of the slot in
which the communication card has been inserted.
• Depending on the slot used, the code numbers differ by an offset of ’500’. To
obtain the code numbers for a communication card inserted in slot 2, an
offset of ’500’ must be added to the code numbers of a card inserted in slot 1.