Lenze EtherCAT control technology - Manual (Page 7)

DMS 3.1 EN 01/2011 TD17
L
7
Control technology | EtherCAT communication manual
About this documentation
1 About this documentation
This documentation ...
 This documentation contains detailed information on how to commission, configure
and diagnose the EtherCAT bus system within the scope of Lenze's control technology.
 belongs to the "PC-based automation" manual collection which consists of the
following documentation:

Note!
For industrial PCs of the EL 1xx, EL x8xx, CS x8xx and CPC x8xx series in control
technology release 2.5, EtherCAT is not supported.
Documentation Subject
System manuals
"PC-based automation"
• Control technology - system structure & configuration
• Control technology - system structure & components
Communication manuals
"PC-based automation"
• CANopen control technology
• Control technology PROFIBUS
• EtherCAT control technology
(Software) Manual
"PC-based automation"
• Industrial PC - parameter setting & configuration
Operating Instructions
"Embedded Line Panel PC"
• EL x7xx - built-in panel-PC with TFT display
Operating Instructions
"Command Station"
• CS x7xx - stand-alone operator terminal
Operating Instructions
"Control Cabinet PC"
• CPC x7xx - control cabinet PC
Operating Instructions
"HMI EL 100"
• EL 1xx - HMI with Windows
®
CE
Further software manuals • »Global Drive Control« (»GDC«)
–IPC as gateway - parameter setting & configuration
• »Engineer«
• »PLC Designer« / »PLC Designer« / »PLC Designer - CANopen for Runtime
Systems«
• »VisiWinNET® Smart«