Rockwell Automation PLC-5 Fieldbus Solutions for Integrated Architecture User Manual User Manual
Page 280
Publication 1757-UM006A-EN-P May 2002
F-32 1788-CN2FF Installation Example
download fails again, remove the FF device and configure again.
Look at the download log and status for ideas.
If you continue to have download problems, refer to
Troubleshooting an Application on page F-51.
In the toolbar at the top of the screen, click on the blue eye to start
the Monitor.
When you run the monitor, you get a display of the values being read
from the attached transmitters.
The Monitor window will appear as shown here. If you have only 3 or
4 function blocks attached to the CN2FF, set the monitor rate to 5
seconds. If you have 20 or so function blocks attached, set it for 10
seconds. The Monitor Data is acquired with messages to the FF
devices and it adds a significant load to the FF network if you ask for
many of readings.
3