Bio-Rad BioLogic Signal Import Module (SIM) - Manual (Page 122)

4. To place methods in a Queue, highlight the method in the Browser and click the Queue icon on the
sidebar. Repeat until all desired methods are in the project Queue. This places each method into your
Project Queue and the Queue Tab window at the bottom of the screen.
• Whenever you highlight the Queue icon under the Project Queue, the list of methods will appear in
the Tab window.
• Multiple methods may be selected in the Browser by either shift/click or control/click.
• Methods will run in the sequence they are listed in the Tab window. The run order of the methods
can be changed by dragging and dropping methods in the queue in the Tab window.
5. After all methods are listed in the project queue, click the Verify Queue button in the right sidebar of the
Tab window to confirm that all methods meet the necessary criteria to be run.
• If the methods meet the necessary run criteria to run correctly, "Methods were successfully verified"
will appear.
• If methods do not meet the necessary run criteria, a list of errors will appear. Errors will appear if
methods are not compatible to run in sequence or the hardware Setup screens are not identical.
• To run your queue, click the Run Queue icon in the right sidebar of the Tab window.
Description of the Queue Icons
Open Method: Opens a highlighted method for editing or viewing in the Protocol
screen.
Delete Method: Deletes a highlighted method from the queue. This is displayed
only prior to the queue running.
Edit Method: Copies the highlighted method, allows you to Rename it and then
opens it for editing in the Protocol screen. This is displayed only when the Queue
has completed its run. Queued methods cannot be edited after the run has started.
Verify Queue: Checks methods in a queue to assure there is not a conflict in the
method Protocol and Setups to prevent running.
If there is a conflict, a list of errors will appear.
If methods are compatible, the message "Methods were successfully verified,"
appears.
Run Queue: Starts a run queue.
Edit Queue: Used to change the name and description of a Queue that has not
been run or to make a copy of a Queue that has been run.
INTRODUCTION TO THE BROWSER SCREEN SYSTEM OPERATION
6-10
Open Method
Delete Method
Edit Method
Verify Queue
Run Queue
Edit Queue