Bio-Rad BioLogic Signal Import Module (SIM) - Manual (Page 148)

Table 7-9.
Miscellaneous
Button Description
To repeat the highlighted step(s) a specified number of times. To highlight more than one
step, hold down the Ctrl key while selecting steps with the mouse.
To pause the method at a specific step during the run. Pause stops the progression of the
method and time, holds the %B composition, and stops the pumps. Time Out Req’d permits
a pause time to be entered. The step will be paused for the specified length of time, after
which it will automatically resume. An audible alarm may be programmed to sound when the
step is paused and when it automatically resumes.
To sound a 10 second audible alarm at the programmed time. The progress of the run will
not be affected.
To zero the detector baseline at a programmed time.
At system start-up, the default condition is Lamp ON. The lamp may be set to turn off at the
end of a run. If the lamp is OFF, it takes about 20 minutes for the lamp to warm up prior to
use.
To start/stop an Econo Gradient Pump at the programmed time for a user-defined task.
To turn the chart recorder on/off at the programmed time. Inserts a step that tells the chart
recorder to start/stop the paper feed and lower/lift the pen.
To display additional steps so that they can be added to the method.
MODES OF OPERATION SYSTEM OPERATION
7-19
Alarm
Zero
Baseline
Lamp
EGP
Chart
Recorder
Repeat
Steps
Pause
Add Step V