Bio-Rad BioLogic Signal Import Module (SIM) - Manual (Page 129)

6.5.4 Active Traces and Values at Cursor
The Active traces and values in the “at cursor” window located in the upper left of the post run screen,
contain two drop-down menus that control which trace axis is displayed on the left and right sides of the
active chromatogram. The scroll bars on the left and right sides of the information box control the scaling of
the trace associated with the left or right drop-down menu. When the vertical crosshatch bar is dragged
across a chromatogram, the values relating to the baseline or peak underneath the crosshatch is reflected in
the upper left corner of the screen. The value for each trace at the cursor position is shown in the dialog.
6.5.5 Chromatogram Settings Tab
The Chromatogram Settings window contains the following tabs to manipulate the display of the
chromatogram:
Visibility In Tile mode each trace device type is displayed along with a check box, legend,
and a run name. Checking or unchecking the boxes causes the traces to be
displayed or hidden.
In Overlay view only the traces selected in "Options/Select Overlay Traces..." or by
the Select button are shown in the chromatogram settings dialog.
The currently active trace is highlighted in blue.
Y-Axis Allows you to set the Baseline and Axis Max values for the currently active trace.
The active trace is selected in the Visibility tab.
X-Axis Allows you to set the Start Time and End Time for the currently active
chromatogram.
INTRODUCTION TO THE BROWSER SCREEN SYSTEM OPERATION
6-17