Bio-Rad BioLogic Signal Import Module (SIM) - Manual (Page 202)

4. Refer to Figure 11-6 for re-assembling the mixer. Make sure that the magnetic stir bar lies flat and
that the O-ring groove in either the mixer barrel or the mixer barrel extender faces up.
Place an O-ring in each O-ring groove. If you are using only the mixer body, then only one O-ring is
required. If either the mixer barrel or the mixer barrel extender is used, then two O-rings are
required.
Figure 11-6. Mixer Assembly
SCREWS
MIXER
BODY
O-RING
750 µ l MIXER
BARREL EXTENDER
OUTLET PORT
O-RING
INLET PORT
MIXER
TOP
MAGNETIC
STIR BAR
O-RING GROOVE
O-RING GROOVE
ASSEMBLY OF THE MX-1 MIXER
MIXER
TOP
SCREWS
MIXER
BODY
12 ml MIXER
BARREL
OUTLET PORT
5 ml MIXER
BARREL EXTENDER
INLET PORT
MAGNETIC
STIR BAR
O-RING
O-RING GROOVE
O-RING GROOVE
ASSEMBLY OF THE MAXIMIZER MIXER
MAINTENANCE MAINTENANCE AND TROUBLESHOOTING
11-9