BECKHOFF AX5000 S-IDN Parameters - Manual (Page 110)

S­IDNs
S­x­0136 Positive acceleration limit value
The parameter limits the maximum drive acceleration to the specified value. The acceleration is positive if
the magnitude of the velocity increases.
Attributes
Name Value
Format udec
Data length 32
Decimal point 2
Min value 0.52
Max value 10737418.24
Default value 6283.18
Unit rad/s 2
Changeable in EtherCAT state PreOp
Cyclic transfer No
Device parameter No
Related to interface revision
This parameter influences the axis control in all position­ and velocity­controlled operating modes. The
dynamics of the control­side set value specification should be lower than the limit configured here, because
otherwise the axis cannot follow the specified acceleration, resulting in discrepancies between the set and
actual positions (following error).
Note
Parameter set switchover is possible!
This IDN exists as S­0­0136; S­1­0136; S­2­0136; S­3­0136; S­4­0136; S­5­0136; S­6­0136
and S­7­0136. Ex factory, all values are identical.
Note
IDNs involved
S‐0‐0160 [ } 118], S‐0‐0161 [ } 119], S‐0‐0162 [ } 120]
AX5000 ­ IDN­Descriptions 110 Version 3.1