Boonton 4500B Peak Power Meter - Manual (Page 276)

Boonton 4500B RF Peak Power Analyzer
Remote Operation 5-76
STATus:OPERation:EVENt?
Description: This query returns the contents of the Operation Event register.
Syntax: STATus:OPERation:EVENt?
Returns: 16-bit register value (0 to 32767)
Valid Modes: Any
STATus:OPERation:NTRansition
Description: Sets the negative transition filter. Setting a bit in the negative transition filter causes a 1 to 0
transition in the corresponding bit of the Operation Status register to cause a 1 to be written in the
associated bit of the Operation Event register.
Syntax: STATus:OPERation:NTRansition <arg>
Argument: <arg> = 0 to 32767
Returns: 16-bit register value (0 to 32767)
Valid Modes: Any
STATus:OPERation:PTRansition
Description: Sets the positive transition filter. Setting a bit in the positive transition filter causes a 0 to 1
transition in the corresponding bit of the Operation Status register to cause a 1 to be written in the
associated bit of the Operation Event register.
Syntax: STATus:OPERation:PTRansition <arg>
Argument: <arg> = 0 to 32767
Returns: 16-bit register value (0 to 32767)
Valid Modes: Any
STATus:PRESet
Description: Sets device dependent SCPI registers to default states. The Operational Enable and Questionable
Enable mask registers are both cleared so an SRQ will not be generated for these conditions, and
the error queue is cleared.
Syntax: STATus:PRESet
Argument: None
Valid Modes: Any