Boonton 4500B Peak Power Meter - Manual (Page 303)

Boonton 4500B RF Peak Power Analyzer
Remote Operation 5-103
Table 5-1. SCPI COMMAND SUMMARY (continued)
MEASure[1|2]:POWer?
Return modulated mode Pavg in dBm
MEASure[1|2]:VOLTage?
Return modulated mode Pavg in equivalent volts
MEMory:DRIVe Set/return active drive letter, A-Z
MEMory:FDOFfset:TBLA:DATA Set/return data array for frequency-dependent offset table A. N max = 60 pairs.
<asc> = Freq1, Ofset1, Freq2, Ofset2 ... FreqN, OfsetN
.
MEMory:FDOFfset:TBLB:DATA Set/return data array for frequency-dependent offset table B. N max = 60 pairs.
<asc> = Freq1, Ofset1, Freq2, Ofset2 ... FreqN, OfsetN
MEMory:FREE? Return the bytes of available memory free on selected drive
MEMory:OVERwrite Set/return the file overwrite state.
MEMory:SNSR[1|2]:CFFAST? Return sensor data
MEMory:SNSR[1|2]:CFSLOW? Return sensor data
MEMory:SNSR[1|2]:INFO? Return sensor data
MEMory:SNSR[1|2]:MESSage? Return sensor data
MEMory:SNSR[1|2]:TEMPCOMP?
Return sensor temperature compensation data
MEMory:SYS:LOAD Recall setup file and configure instrument. <arg> = filename with path but no
extension
MEMory:SYS:STORe
Build an instrument setup file and save to file. <arg> = filename with path but no
extension
MMEMory:COPY Copy from source argument to destination argument. (Ex: <args> = CH1 MEM2)
MMEMory:LOAD Read a reference waveform from disk into a reference channel. (Ex: <args> =
filename MEM2)
MMEMory:SAVE:DISPlay
Copy from display to destination argument.
MMEMory:STORe Write a waveform to disk from a specified channel. (Ex: <args> = TRIG1 filename)
OUTPut:LEVel:POWer
Set calibrator output level. <arg> = -50.0 to 20.0 dBm
OUTPut:LEVel:LIMit Set maximum power level for calibrator output. <arg> = -50.0 to 20.0 dBm
OUTPut:LEVel:STEP Set power step size for calibrator output level. <arg> = 0.1 to 60.0 dB
OUTPut:MODUlation Set calibrator to selected output mode. <arg> = CW, PULSE
OUTPut:POLArity Set calibrator edge to selected edge. <arg> = POS, NEG