Boonton 4500B Peak Power Meter - Manual (Page 33)

Boonton 4500B RF Peak Power Analyzer
Installation 2-5
9. Verify that the Instrument Serial Number matches the number on the label at the top center of the rear
panel. See Figure 3-2. If an improper serial number appears on the screen, contact Boonton Electronics
for technical support.
10. Follow steps in Sections 3.4 and 3.5 to initialize and calibrate the instrument.
Note You will not be able to perform measurements with the Model 4500B until an AutoCal
procedure (see Section 3.5) has been performed on the measurement channel. However,
AutoCal data is saved when power is removed, so AutoCal need not be repeated with each
power-on.
.
.
Figure 2-3. Util > Inst Status Display