Disable switch port flow, Syntax, Parameter – Allied Telesis AT-S63 User Manual
Page 105: Description, Example
Advertising
AT-S63 Management Software Command Line Interface User’s Guide
105
DISABLE SWITCH PORT FLOW
Syntax
disable switch port=
port
flow=pause
Parameter
port
Specifies the port where you want to deactivate flow
control. You can specify more than one port at a time.
You can specify the ports individually (for example,
5,7,22), as a range (for example, 18-23), or both (for
example, 1,5,14-22).
Description
This command deactivates flow control on a port. Flow control only applies
to ports operating in full duplex mode. This command performs the same
function as the
flowcontrol=disabled
option in the SET SWITCH PORT
command.
Example
The following command deactivates flow control on port 6:
disable switch port=6 flow=pause
Advertising