Allied Telesis AT-S63 - Manual (Page 372)

Chapter 23: STP Commands
372
shown in Table 10. You specify the increment of the
desired value. The default is 128 (increment 8).
Description
This command configures the following STP parameter settings for a
switch port:
ˆ Port cost
ˆ Port priority
Examples
The following command sets the port cost to 15 and the port priority to 192
(increment 12) for port 6:
set stp port=6 portcost=15 portpriority=12
The following command sets the port cost to auto-detect on ports 7 to 10:
set stp port=7-10 portcost=auto
Table 10. Port Priority Value Increments
Increment
Port
Priority
Increment
Port
Priority
0 0 8 128
1 16 9 144
2 32 10 160
3 48 11 176
4 64 12 192
5 80 13 208
6 96 14 224
7 112 15 240