Show log output, Syntax, Parameters – Allied Telesis AT-S63 User Manual
Page 206: Description, Example
Advertising
Chapter 14: Event Log Commands
206
SHOW LOG OUTPUT
Syntax
show log output[=
output-id
] [full]
Parameters
output
Specifies the output definition ID number. If an output
ID number is not specified, all output definitions
currently configured on the switch are displayed.
full
Displays the details of the output definition. If not
specified, only a summary is displayed.
Description
This command displays output definition details.
Example
The following command displays output definition number 5 in full mode:
show log output=5 full
Advertising