Allied Telesis AT-S63 - Manual (Page 81)

AT-S63 Management Software Menus Interface User’s Guide
Section I: Basic Features 81
string that has a closed access status. (Management station IP
addresses are displayed only when you specify a specific community
string using the COMMUNITY parameter in this command.) To add IP
addresses of management stations to a community string, refer to
“ADD SNMP COMMUNITY” on page 66.
ˆ Trap receiver IP addresses - These are the IP addresses of
management stations to receive SNMP traps from the switch. (IP
addresses or trap receivers are displayed only when you specify a
specific community string using the COMMUNITY parameter in this
command.) To add IP addresses to a community string, refer to “ADD
SNMP COMMUNITY” on page 66.
ˆ Access Status - If a community string shows an Open Access with Yes,
the string has an open access status, meaning any management
stations can use the string. A string with a Open Access of No has a
closed access status; only those management stations whose IP
addresses have been assigned to the string can use it. To change the
access status, refer to “SET SNMP COMMUNITY” on page 78.
Examples
The following command displays the SNMP status and the community
strings on the switch:
show snmp
The following command displays specific information about the “private”
community string. The information includes the IP addresses of
management stations that can use the string and the IP addresses of
SNMP trap receivers:
show snmp community=private