Set lacp state, Syntax, Parameters – Allied Telesis AT-S63 User Manual
Page 145: Description, Example
Advertising
AT-S63 Management Software Command Line Interface User’s Guide
145
SET LACP STATE
Syntax
set lacp state=[enable|disable]
Parameters
state
The state of LACP on the switch. The options are:
enable
Enables LACP. This option performs the same
function as “ENABLE LACP” on page 142.
disable
Disables LACP. This is the default. This option
performs the same function as “DISABLE
LACP” on page 141.
Description
This command enables or disables LACP.
Example
The following command enables LACP on the system:
set lacp state=enable
Advertising