Allied Telesis AT-S63 - Manual (Page 386)

Chapter 24: RSTP Commands
386
SHOW RSTP
Syntax
show rstp [portconfig= port |portstate= port ]
Parameters
portconfig Displays the RSTP port settings. You can specify more
than one port at a time.
portstate Displays the RSTP port status. You can specify more
than one port at a time.
Description
You can use this command to display the RSTP parameter settings.
Values are displayed for the following parameters:
ˆ RSTP status
ˆ Bridge identifier
ˆ Bridge priority
ˆ Hello time
ˆ Maximum aging
ˆ Forwarding delay
You can also use this command to view the following RSTP parameter
settings for a switch port:
ˆ Port cost
ˆ Port priority
ˆ Edge and point-to-point status
Examples
The following command displays the bridge’s RSTP settings:
show rstp
The following command displays the RSTP port settings for ports 1 to 4:
show rstp portconfig=1-4