Show ip interface, Syntax, Parameter – Allied Telesis AT-S63 User Manual
Page 60: Description, Example
Advertising
Chapter 3: Basic Switch Commands
60
SHOW IP INTERFACE
Syntax
show ip interface=eth0
Parameter
interface
Specifies the switch’s interface number. This value is
always eth0.
Description
This command displays the current values for the following switch
parameters:
IP address
Subnet mask
Default gateway
To manually set the IP address and subnet mask, refer to “SET IP
INTERFACE” on page 48. To manually set the default gateway address,
refer to “SET IP ROUTE” on page 50.
Example
The following command displays the IP address, subnet mask, and default
gateway of the switch:
show ip interface=eth0
Advertising