Enable stp, Syntax, Parameters – Allied Telesis AT-S63 User Manual
Page 366: Description, Example
Advertising
Chapter 23: STP Commands
366
ENABLE STP
Syntax
enable stp
Parameters
None.
Description
This command enables the Spanning Tree Protocol on the switch. The
default setting for STP is disabled. To view the current status of STP, refer
to “SHOW STP” on page 373.
Note
You cannot enable STP until after you have activated it with
“ACTIVATE STP” on page 364.
Example
The following command enables STP on the switch:
enable stp
Advertising