Allied Telesis AT-S63 - Manual (Page 429)

429
Chapter 27
GARP VLAN Registration Protocol
Commands
This chapter contains the following commands:
ˆ “DISABLE GARP” on page 430
ˆ “ENABLE GARP” on page 431
ˆ “PURGE GARP” on page 432
ˆ “SET GARP PORT” on page 433
ˆ “SET GARP TIMER” on page 434
ˆ “SHOW GARP” on page 436
ˆ “SHOW GARP COUNTER” on page 437
ˆ “SHOW GARP DATABASE” on page 439
ˆ “SHOW GARP GIP” on page 440
ˆ “SHOW GARP MACHINE” on page 441
Note
Remember to save your changes with the SAVE CONFIGURATION
command.
Note
You cannot convert a dynamic GVRP VLAN or port to a static VLAN
or port using the command line interface. That is possible only from
the menus interface. For background information on GVRP, refer to
Chapter 24, “GARP VLAN Registration Protocol” in the AT-S63
Management Software Menus Interface User’s Guide.