Allied Telesis AT-S63 - Manual (Page 186)

Chapter 14: Event Log Commands
186
ADD LOG OUTPUT
Syntax
add log output= output-id module=[all| module ]
severity=[all| severity ]
Parameters
output Specifies the output definition ID number.
module Specifies what AT-S63 events to filter. The available
options are:
all Processes events for all modules. This is
the default.
module Processes events for specific module(s).
You can select more than one module at a
time, for example, MAC,PACCESS. For a
list of modules, see Table 4, “AT-S63
Modules” on page 202.
severity Specifies the severity of events to be filtered. The
options are:
all Processes events of all severity levels.
This is the default
severity Processes events of a particular severity.
Choices are I for Informational, E for Error,
W for Warning, and D for Debug. You can
select more than one severity at a time (for
example, E,W). For a definition of the
severity levels, see Table 5, “Event Log
Severity Levels” on page 204.
Description
This command adds an event filter to the output definition you create with
“CREATE LOG OUTPUT” on page 188. You must create the output
definition before you add filters.
Example
The following command creates a log filter for output definition 3 that
processes all messages related to enhanced stacking with an error
severity level: