Enable interface linktrap, Syntax, Parameter – Allied Telesis AT-S63 User Manual
Page 106: Description, Example
Advertising
Chapter 7: Port Parameter Commands
106
ENABLE INTERFACE LINKTRAP
Syntax
enable interface=
port
linktrap
Parameter
port
Specifies the port on which you want to enable link
traps. You can specify more than one port at a time.
You can specify the ports individually (for example,
5,7,22), as a range (for example, 18-23), or both (for
example, 1,5,14-22).
Description
This command enables link traps on the port.
Note
SNMP must be enabled and correctly configured to generate traps
and, therefore, allow you to enable link traps on a specific port.
Example
The following command enables link traps on port 21:
enable interface=21
Advertising