Enable switch port, Syntax, Parameter – Allied Telesis AT-S63 User Manual
Page 107: Description, Example
Advertising
AT-S63 Management Software Command Line Interface User’s Guide
107
ENABLE SWITCH PORT
Syntax
enable switch port=
port
Parameter
port
Specifies the port to enable. You can specify more than
one port at a time. You can specify the ports individually
(for example, 5,7,22), as a range (for example, 18-23),
or both (for example, 1,5,14-22).
Description
This command enables a port. After enabled, a port begins to forward
traffic. The default setting for a port is enabled. This command performs
the same function are the STATUS option is the SET SWITCH PORT
command.
Example
The following command enables ports 1 to 4:
disable switch port=1-4
Advertising