Set lacp priority, Syntax, Parameters – Allied Telesis AT-S63 User Manual
Page 144: Description, Example
Advertising
Chapter 10: LACP Commands
144
SET LACP PRIORITY
Syntax
set lacp priority=
priority
Parameters
priority
The priority level of the port, a hexadecimal number
between 0x1 and 0xffff. The lower the number, the
higher the priority.
Description
This command sets the priority of the switch. LACP uses the priority to
resolve conflicts between two switches to decide which switch makes the
decision about which ports to aggregate.
Example
The following command sets the priority of the system to 0x8000:
set lacp priority=0x8000
Advertising