Allied Telesis AT-S63 - Manual (Page 192)

Chapter 14: Event Log Commands
192
DISABLE LOG OUTPUT
Syntax
disable log output[= output-id ]
Parameters
output Specifies the output definition ID number to disable.
Description
This command disables the specified output definition and no log
messages are processed by this definition although the definition still
exists. To permanently remove an output definition, see “DESTROY LOG
OUTPUT” on page 190. To enable the output definition again, see
“ENABLE LOG OUTPUT” on page 194.
Example
The following command disables (but does not delete) output definition
number 7:
disable log output=7
The following command disables all configured definitions:
disable log output