Allied Telesis AT-S63 - Manual (Page 176)

Chapter 13: File System Commands
176
SHOW CONFIG
Syntax
show config [dynamic] [info]
Parameters
dynamic Displays the settings for all the switch and port
parameters in command line format.
info Displays the settings for all the switch and port
parameters.
Description
This command, when used without any parameter, displays two pieces of
information. The first is the “Boot configuration file.” This is the
configuration file the switch uses the next time it is reset or power cycled.
This is also the configuration file the switch uses to save your
configuration changes when you use the SAVE CONFIGURATION
command. To change the boot configuration file, refer to “SET CONFIG”
on page 173.
The second piece of information is the “Current Configuration.” This is the
boot configuration file the switch used the last time it was reset or power
cycled.
The DYNAMIC parameter displays all the switch settings but in command
line format for those switch parameters that have been changed from their
default settings.
Adding the INFO parameter to the command displays all the switch
settings. It performs the same function as all the other SHOW commands
in one command.
Examples
The following command displays the names of the current configuration
files:
show config
The following command displays all the switch settings:
show config info