Allied Telesis AT-S63 - Manual (Page 363)

363
Chapter 23
STP Commands
This chapter contains the following commands:
ˆ “ACTIVATE STP” on page 364
ˆ “DISABLE STP” on page 365
ˆ “ENABLE STP” on page 366
ˆ “PURGE STP” on page 367
ˆ “SET STP” on page 368
ˆ “SET STP PORT” on page 371
ˆ “SHOW STP” on page 373
Note
Remember to save your changes with the SAVE CONFIGURATION
command.
Note
For background information on the Spanning Tree Protocol (STP).,
refer to Chapter 21, “STP and RSTP” in the AT-S63 Management
Software Menus Interface User’s Guide.