Reset switch port, Syntax, Parameter – Allied Telesis AT-S63 User Manual
Page 110: Description, Example
Advertising
Chapter 7: Port Parameter Commands
110
RESET SWITCH PORT
Syntax
reset switch port=
port
Parameter
port
Specifies the port to reset. You can specify the ports
individually (for example, 5,7,22), as a range (for
example, 18-23), or both (for example, 1,5,14-22).
Description
This command resets a port. The reset takes less that a second to
complete. You might reset a port if it is experiencing a problem
establishing a link with its end node. The port retains its current operating
parameter settings. This command performs the same function as the
SOFTRESET parameter in the SET SWITCH PORT command. To reset a
port to the factory default settings, use “PURGE SWITCH PORT” on
page 109.
Example
The following command resets ports 5 to 8:
reset switch port=5-8
Advertising