Allied Telesis AT-S63 - Manual (Page 65)

Section I: Basic Features 65
Chapter 4
SNMPv2 and SNMPv2c Commands
This chapter contains the following commands:
ˆ “ADD SNMP COMMUNITY” on page 66
ˆ “CREATE SNMP COMMUNITY” on page 68
ˆ “DESTROY SNMP COMMUNITY” on page 71
ˆ “DISABLE SNMP” on page 72
ˆ “DISABLE SNMP AUTHENTICATETRAP” on page 73
ˆ “DISABLE SNMP COMMUNITY” on page 74
ˆ “ENABLE SNMP” on page 75
ˆ “ENABLE SNMP AUTHENTICATETRAP” on page 76
ˆ “ENABLE SNMP COMMUNITY” on page 77
ˆ “SET SNMP COMMUNITY” on page 78
ˆ “SHOW SNMP” on page 80
Note
Remember to save your changes with the SAVE CONFIGURATION
command.
Note
For background information on SNMPv1 and SNMPv2c, refer to
Chapter 4, “SNMPv1 and SNMPv2c” in the AT-S63 Management
Software Menus Interface User’s Guide.