Restart reboot, Syntax, Parameters – Allied Telesis AT-S63 User Manual
Page 44: Description, Example
Advertising
Chapter 3: Basic Switch Commands
44
RESTART REBOOT
Syntax
restart reboot
Parameters
None.
Description
This command resets the switch. The switch runs its internal diagnostics,
loads the AT-S63 management software, and configures its parameter
settings using the current boot configuration file. The reset takes
approximately 20 to 30 seconds to complete. The switch does not forward
traffic during the time required to run its internal diagnostics and initialize
its operating software. Some network traffic may be lost.
Note
Be sure to use the SAVE CONFIGURATION command to save your
changes before resetting the switch. Any unsaved changes are lost.
Example
The following resets the switch:
restart reboot
Advertising