Allied Telesis AT-S63 - Manual (Page 196)

Chapter 14: Event Log Commands
196
SAVE LOG
Syntax
save log[=permanent|temporary] filename= filename .log [full]
[module= module ] [reverse] [severity=all| severity ]
[overwrite]
Parameters
log Specifies the source of the events you want to save
to the log file. The options are:
permanent Permanent (nonvolatile) memory.
Saves events stored in nonvolatile
memory, which can contain up to
2,000 events.
temporary Temporary memory. Saves events
stored in temporary memory, which
can contain up to 4,000 events. This is
the default if you do not specify the
“permanent” option.
filename Specifies the filename for the log. The name can be
up to 16 alphanumeric characters, followed by the
extension ”.log.” Spaces are allowed. The filename
must be enclosed in quotes if it contains spaces.
Otherwise, the quotes are optional.
full Specifies the amount of information saved to the log.
Without this option, the log saves only the time,
module, severity, and description for each entry. With
it, the log also saves the filename, line number, and
event ID.
module Specifies the AT-S63 module whose events are to be
saved. For a list of modules, refer to Table 4 on
page 202.
reverse Specifies the order of the events in the log. Without
this option, the events are saved oldest to newest.
With this option, the events are saved newest to
oldest.
severity Specifies the severity of events to be filtered. The
options are:
all Saves events of all severity levels. This is
the default