Allied Telesis AT-S63 - Manual (Page 405)

AT-S63 Management Software Command Line Interface User’s Guide
405
SET MSTP PORT
Syntax
set mstp port= port |all [intportcost=auto| portcost ]
[extportcost= portcost ] [portpriority= priority ]
[edgeport=yes|no|no|on|off|true|false]
[ptp|pointtopoint=yes|no|on|off|true|false|autoupdate]
[migrationcheck=yes|no|on|off|true|false]
Parameters
port Specifies the port you want to configure. You can
specify more than one port at a time. To configure all
ports in the switch, enter ALL.
intportcost Specifies the cost of a port connected to a bridge that is
part of the same MSTP region. This is referred to as an
internal port cost. The range is 0 to 200,000,000. The
default setting is Auto-detect (0), which sets port cost
depending on the speed of the port. Default values are
2,000,000 for 10 Mbps ports, 200,000 for a 100 Mbps
ports, and 20,000 for one gigabit ports.
extportcost Specifies the cost of a port connected to a bridge which
is a member of another MSTP region or is running STP
or RSTP. This is referred to as an external port cost.
The range is 0 to 200,000,000. The default setting is
200,000.
portpriority Specifies the port’s priority. This parameter is used as a
tie breaker when two or more ports are determined to
have equal costs to the root bridge. The range is 0 to
240 in increments of 16, for a total of 16 increments, as
shown in Table 17 on page 406. You specify the
increment of the desired value. The default is 128,
which is increment 8.