Enable sntp, Syntax, Parameters – Allied Telesis AT-S63 User Manual
Page 87: Description, Example
Advertising
AT-S63 Management Software Command Line Interface User’s Guide
87
ENABLE SNTP
Syntax
enable sntp
Parameters
None.
Description
This command enables the SNTP client software on the switch. The
default setting for SNTP is disabled. After enabled, the switch will obtain its
date and time from an SNTP server, assuming that you have specified a
server IP address with “ADD SNTPSERVER PEER|IPADDRESS” on
page 84.
Example
The following command enables the SNTP client software:
enable sntp
Advertising