Purge mstp, Syntax, Parameters – Allied Telesis AT-S63 User Manual
Page 397: Example
Advertising
AT-S63 Management Software Command Line Interface User’s Guide
397
PURGE MSTP
Syntax
purge mstp
Parameters
None.
This command returns all MSTP bridge and port parameters settings to
their default values.
In order for you to use this command, MSTP must be the active spanning
tree protocol on the switch and the protocol must be disabled. To select
MSTP as the active spanning tree protocol on the switch, see “ACTIVATE
MSTP” on page 390. To disable MSTP, refer to “DISABLE MSTP” on
page 395.
Example
The following command resets the MSTP bridge and port parameter
settings:
purge mstp
Advertising