Allied Telesis AT-S63 - Manual (Page 146)

Chapter 10: LACP Commands
146
SHOW LACP
Syntax
show lacp [port= port ] [aggregator =name ] [machine]
Parameter
port Specifies the port(s) to display. You can specify the
ports individually (for example, 5,7,22), as a range (for
example, 18-20), or both (for example, 1,14-16).
aggregator Specifies the name of the aggregator.
Description
This command displays the configuration and/or machine states of the
ports, and/or the aggregators.
Examples
The following command displays general LACP status information:
show lacp
The following command displays the LACP configuration for ports 13 and
16:
show lacp port=13,16
The following command displays the configuration of the aggregators on
the system:
show lacp aggregator
The following command displays the LACP machine states for each port
on the system:
show lacp machine