Allied Telesis AT-S63 - Manual (Page 231)

AT-S63 Management Software Command Line Interface User’s Guide
231
SET DOS LAND
Syntax
set dos land port= port state=enable|disable
[mirrorport= port ]
Parameters
port Specifies the switch port on which you want to enable
or disable the Land defense. You can specify more than
one port at a time.
state Specifies the state of the Land defense. The options
are:
enable Activates the defense.
disable Deactivates the defense. This is the default.
mirrorport Specifies a port where invalid traffic is copied. You can
specify only one port.
Description
This command enables and disables the Land DoS defense. For an
explanation of this attack and the AT-S63 defense mechanism, refer to
Chapter 31, “Denial of Service Defense” in the <Italic>AT-S63
Management Software Menus Interface User’s Guide.
Example
The following command activates the Land defense on ports 5 and 7:
set dos land port=5,7 state=enable