Set ip igmp, Syntax, Parameters – Allied Telesis AT-S63 User Manual
Page 290
Chapter 20: IGMP Snooping Commands
290
SET IP IGMP
Syntax
set ip igmp [snoopingstatus=enabled|disabled]
[hoststatus=singlehost|multihost] [timeout=
value
]
[numbermulticastgroups=
value
]
[routerport=
port
|all|none|auto]
Parameters
snoopingstatus
Activates and deactivates IGMP snooping
on the switch. The options are:
enabled
Activates IGMP snooping.
disabled
Deactivates IGMP snooping.
This is the default setting
hoststatus
Specifies the IGMP host node topology.
Options are:
singlehost
Activates the Single-Host/Port
setting, which is appropriate
when there is only one host
node connected to a port on
the switch. This is the default
setting.
multihost
Activates the Multi-Host
setting, which is appropriate if
there is more than one host
node connected to a switch
port.
timeout
Specifies the time period, in seconds, used
by the switch in determining inactive host
nodes. An inactive host node is a node that
has not sent an IGMP report during the
specified time interval. The range is 1 to
86,400 seconds (24 hours); the default is
260 seconds.