Allied Telesis AT-S63 - Manual (Page 111)

AT-S63 Management Software Command Line Interface User’s Guide
111
SET SWITCH PORT
Syntax
set switch port= port
[backpressure=yes|no|on|off|true|false|enabled|disabled]
[bc=yes|no|on|off|true|false|enabled|disabled]
[bplimit=
value ] [description= description ] [fctrllimit= value ]
[flowcontrol=disabled|enabled]
[holbplimit=
value ] [intrusionaction=discard|trap|disable]
[mdimode=mdi|mdix] [mirror=none|rx|tx|both]
[overridepriority=yes|no|on|off|true|false]
[participate=yes|no|on|off|true|false] [priority=
value ]
[renegotiation=auto]
[securitymode=automatic|limited|secured|locked|pacontrol]
[softreset]
[speed=autonegotiate|10mhalf|10mfull||100mhalf|100mfull]
[status=enabled|disabled]
Parameters
port Specifies the port you want to configure. You
can specify more than one port at a time, but the
ports must be of the same medium type. For
example, you cannot configure twisted pair and
fiber optic ports with the same command. You
can specify the ports individually (for example,
5,7,22), as a range (for example, 18-23), or both
(for example, 1,5,14-22).
backpressure Controls back pressure on the port. Back
pressure applies only to ports operating in half-
duplex mode. The options are:
yes, on, true, enabled Activates back pressure
on the port. These
options are equivalent.
no, off, false, disabled Deactivates back
pressure on the port.
This is the default.
These options are
equivalent.
bc Controls the broadcast filter. The options are:
yes, on, true, enabled The port forwards
broadcast frames.
These options are
equivalent.
no, off, false, disabled The port discards all