Allied Telesis AT-S63 - Manual (Page 138)

Chapter 7: Static and LACP Port Trunks
138 Section I: Basic Features
The Create Trunk menu is shown in Figure 39.
Figure 39. Create Trunk Menu
5. Configure the following parameters as necessary:
1 - Trunk ID
Specifies the trunk ID. Enter an ID number for the trunk, from 1 to 6. A
trunk must be assigned a unique ID number. The default value is the
next unused ID number.
2 - Trunk Name
Specifies the trunk name. Enter a name for the trunk. The name can
be up to 16 alphanumeric characters. No spaces or special characters,
such as asterisks and exclamation points, are allowed. Each trunk
must have a unique name.
3 - Trunk Method
Specifies the load distribution method. The possible settings are:
ˆ SRC MAC - Source MAC address
ˆ DST MAC - Destination MAC address
ˆ SRC/DST MAC - Source address /destination MAC address
ˆ SRC IP - Source IP address trunking
ˆ DST IP - Destination IP address trunking
ˆ SRC/DST IP - Source address /destination IP address
The default is SRC/DST MAC. For background information, refer to
“Load Distribution Methods” on page 134.
4 - Port Range
Specifies the ports of the trunk. A trunk can contain up to eight ports.
You can identify the ports individually (for example, 3,7,10), as a range
(for example, 5-11), or both (for example, 2,4,11-14).
Allied Telesyn Ethernet Switch AT-9400 Series - AT-S63
Marketing
User: Manager 11:20:02 02-Mar-2005
Create Trunk
1 - Trunk ID ......... 1
2 - Trunk Name .......
3 - Trunk Method ..... SRC/DST MAC
4 - Trunk Ports ......
C - Create Trunk
R - Return to Previous Menu
Enter your selection?