Configuring rstp port settings – Allied Telesis AT-S63 User Manual
Page 495
AT-S63 Management Software Menus Interface User’s Guide
Section IV: Spanning Tree Protocols
495
breaker in the selection of the root bridge when two or more bridges
have the same bridge priority value. This value cannot be changed.
4. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Configuring
RSTP Port
Settings
To adjust RSTP port parameters, perform the following procedure:
1. From the Main Menu, type 3 to select Spanning Tree Configuration.
The Spanning Tree Configuration menu is shown in Figure 169 on
page 485.
2. From the Spanning Tree Configuration menu, type 3 to select
Configure Active Protocol.
The RSTP menu is shown in Figure 170 on page 487.
3. From the Spanning Tree Configuration menu, type 3 to select STP
Configuration.
The STP menu is shown in Figure 170 on page 487.
4. From the STP menu, type P to select RSTP Port Parameters.
The RSTP Port Parameters menu is shown in Figure 175.
Figure 175. RSTP Port Parameters Menu
5. Type 1 to select Configure RSTP Port Settings.
The following prompt is displayed:
Starting Port to Configure [1 to 24] ->
6. Enter the number of the port you want to configure. To configure a
range of ports, enter the first port of the range.
The following prompt is displayed:
Allied Telesyn Ethernet Switch AT-94xx - AT-S63
Marketing
User: Manager
11:20:02 02-Mar-2005
RSTP Port Parameters
1 - Configure RSTP Port Settings
2 - Display RSTP Port Configuration
3 - Display RSTP Port State
R - Return to Previous Menu
Enter your selection?