Allied Telesis AT-S63 - Manual (Page 665)

AT-S63 Management Software Menus Interface User’s Guide
Section IV: Port Security 665
The Configure Supplicant Port Access Parameters menu is shown in
Figure 239.
Figure 241. Configure Supplicant Port Access Parameters Menu
6. Adjust the following parameters as necessary.
1 - Auth Period
This parameter specifies the period of time in seconds that the
supplicant waits for a reply from the authenticator after sending an
EAP-Response frame. The range is 1 to 60 seconds. The default is 30
seconds.
2 - Held Period
The held period specifies the amount of time in seconds the supplicant
is to refrain from retrying to re-contact the authenticator in the event
the end user provides an invalid username and/or password. After the
time period has expired, the supplicant can attempt to log on again.
The range is 0 to 65,535. The default value is 60.
3 - Max Start
Max start is the maximum number of times the supplicant sends
EAPOL-Start frames before assuming that there is no authenticator
present. The range is 1 to 10. The default is 3.
4 - Start Period
The start period is the time period in seconds between successive
attempts by the supplicant to establish contact with an authenticator
when there is no reply. The range is 1 to 60. The default is 30.
5 - User Name
The user name is the username for the switch port. The port sends the
name to the authentication server for verification when the port logs on
to the network. The username can be from 1 to 16 alphanumeric
characters (A to Z, a to z, 1 to 9). Do not use spaces or special
Allied Telesyn Ethernet Switch AT-94xx - AT-S63
Marketing
User: Manager 11:20:02 02-Mar-2005
Configure Supplicant Port Access Parameters
Configuring Port 5-8
1 - Auth Period........... 30 Seconds
2 - Held Period........... 60 Seconds
3 - Max Start ........... 3
4 - Start Period.......... 30 Seconds
5 - User Name: ...........
6 - User Password: .......
R - Return to Previous Menu
Enter your selection?