Allied Telesis AT-S63 - Manual (Page 87)

AT-S63 Management Software Menus Interface User’s Guide
Section I: Basic Operations 87
Enter Community Status [E-Enable, D-Disable]:
c. Type E to enable the community string or D to disable it. This
confirmation prompt is displayed:
Do you want to change Community Status? (Y/N): [Yes/No] ->
d. Type Y to change the string’s status or N to cancel the change.
e. After making changes, type R until you return to the Main Menu.
Then type S to select Save Configuration Changes.
5 - Set Community Open Status
Use this selection to change a string’s open status. A string with an
open status can be used by any network administrator. A string with a
closed status can only be used from management workstations whose
IP addresses are assigned to the community string. To use the option,
do the following:
a. From the Modify SNMP Community menu, type 5 to select Set
Community Open Status. The following prompt is displayed:
Enter SNMP Community Name:
b. Enter the community string you want to modify. Community strings
are case sensitive. The following prompt is displayed:
Enter Open Access Status [Y-Yes, N-No]:
c. Type Y to assign the string an open status or N to assign it a closed
status. This confirmation prompt is displayed:
D o you want to change Open Access Status? (Y/N): [Yes/No] - >
d. Type Y to change the string’s open status or N to cancel the
change.
e. After making changes, type R until you return to the Main Menu.
Then type S to select Save Configuration Changes.