Allied Telesis AT-S63 - Manual (Page 576)

Chapter 23: Port-based and Tagged VLANs
576 Section V: VLANs
Resetting to the Default VLAN
The following procedure for deletes all VLANs, except the Default_VLAN,
on a switch. To delete selected VLANs, perform the procedure in “Deleting
a VLAN” on page 573.
To return all ports to the default VLAN, perform the following procedure:
1. From the Main Menu, type 2 to select VLAN Configuration.
The VLAN Configuration menu is shown in Figure 198 on page 561.
2. From the VLAN Configuration menu, type 4 to select Configure VLANs.
The Configure VLANs menu is shown in Figure 199 on page 562.
Note
If selection 4, Configure VLANs, is not displayed in the menu, the
switch is running in a multiple VLAN mode. To change a switch’s
VLAN mode, refer to “Selecting a VLAN Mode” on page 616.
3. From the Configure VLANs menu, type 4 to select Reset to Default
VLAN.
The following prompt is displayed:
This operation deletes ALL user created VLANs!
Do you want to continue [Yes/No] ->
4. Type Y to delete all VLANs or N to cancel the procedure. Press
Return.
If you select Yes, all VLANs are deleted and the following message is
displayed:
SUCCESS
Please make sure to manually update any static
multicast MAC address(es) entries.
Press any key to continue...
All tagged and untagged ports are returned to the Default_VLAN as
untagged ports.
Any static addresses assigned to the ports of the VLANs are now
obsolete, except for the Default_VLAN, because the VLANs have
been deleted. Those addresses should be deleted from the MAC
address table. For instructions on how to delete addresses, refer to
“Deleting All Dynamic MAC Addresses” on page 681.
5. Press any key.