Allied Telesis AT-S63 - Manual (Page 58)

Chapter 3: Basic Switch Parameters
58 Section I: Basic Operations
Setting the System Time
This procedure explains how to set the switch’s date and time. Setting the
system time is important if you configured the switch to send traps to your
management stations. Traps from a switch where the time has not been
set do not contain the correct date and time. Therefore, it becomes difficult
for you to determine when the events represented by the traps occurred.
It is also important to set the system time if you intend to use the Secure
Sockets Layer (SSL) certificate feature described in, Chapter 32, ”PKI
Certificates and SSL” on page 719. Certificates must contain the date and
time when they are created.
There are two ways to set the switch’s time. One method is to set it
manually. There is, however, a drawback to this method. The switch loses
the values when reset or power cycled. When you use this method you
must reset the values whenever you reset the device.
The second method uses the Simple Network Time Protocol (SNTP). The
AT-S63 management software is shipped with the client version of this
protocol. You can configure the AT-S63 management software to obtain
the current date and time from an SNTP or Network Time Protocol (NTP)
server located on your network or the Internet.
SNTP is a reduced version of the NTP. However, the SNTP client software
in the AT-S63 management software is interoperable with NTP servers.
Note
The default system time on the switch is midnight, January 1, 1970.
Setting the
System Time
Manually
To set the system time manually, perform the following procedure:
1. From the Main Menu, type 5 to select System Administration.
The System Administration menu is shown in Figure 4 on page 46.
2. From the System Administration menu, type 2 to select System
Configuration.
The System Configuration menu is shown in Figure 5 on page 47.
3. From the System Configuration menu, type 8 to select Configure
System Time.