Allied Telesis AT-S63 - Manual (Page 687)

AT-S63 Management Software Menus Interface User’s Guide
Section VII: Management Security 687
Configuring the Web Server
This procedure explains how to enable and disable the web server and
how to configure the HTTP and HTTPS settings from a local or Telnet
management session. The default setting for the web server is enabled,
with the non-secure HTTP mode as the active web server mode.
Before you configure the web server, please note the following:
ˆ You cannot make any changes to the HTTP or HTTPS settings while
the web server is enabled. You must first disable the web server before
making changes.
ˆ To configure the web server for the HTTPS secure mode, you must
first create an encryption key and a certificate, and add the certificate
to the certificate database. The AT-S63 management software does
not allow you to configure the web server for the HTTPS secure mode
until those steps have been completed. For instructions, refer to
Chapter 31, “Encryption Keys” on page 693, and Chapter 32, “PKI
Certificates and SSL” on page 719.
ˆ To make a change to an HTTP or HTTPS setting, you must perform
the entire procedure. For example, to change the port number for
HTTP, you must first disable the web server and then reselect HTTP.
To configure the web server, perform the following procedure:
1. From the Main Menu, type 5 to select System Administration.
The System Administration menu is shown in Figure 4 on page 46.
2. From the System Administration menu, type 4 to select Web Server
Configuration.